Simple install :

1.) Press F2
2.) Press ENTER
3.) Press ENTER

That's all. Now start "YO! JOE!". (simply enter "JOE" at DOS-prompt)

REMARK: For trouble shooting look also in INFO.EXE and game instructions.

 VIDEO 
*** Video-adapters ***
Ŀ
 Setup:    Video adapter                                                  
Ĵ
 Type 1  - ET4000                                                         
         - Trident                                                        
         - PS/2 Model 50                                                  
         - Compaque Deskpro                                               
           and some other video-adapters                                  
Ĵ
 Type 2  - ET3000                                                         
           and some other video-adapters                                  
Ĵ
 Type 3   almost any other video-adapters                                 

REMARK : Change video-adapter-type in SETUP.EXE only, if there are
         errors during the scrolling or if some graphics are "flickering".
         Try type 1 first

**** Video-frequency ****

Choose 50 Hz mode. Only if your monitor is not able to display 50 Hz
change to 60 Hz mode (and than to 70 Hz).

REMARK: If you choose a higher video-frequency, the game will be
        faster and it will become more difficult.


 MISC 

Install two players:

1 player-mode : This requires 480 K RAM only !
                But you can't play the two-playermode.

2 player-mode : This requires at least 580 K RAM.
                Choose 1 playermode,if "YO! JOE!" reports
                "Out of memory"-error.


Joystick:

The joystick is autodetected (and calibrated) at the start of "YO! JOE!".
Choose "no joystick" to disable autodetect.

Panelman:

There are two little panelmen (in the panel at the score-display).
Disable panelmen to save time only.

 SOUND 

REMARK: No music is supported in the DEMO-version (to save disk-memory).

Ŀ
Setup entry  Remark                                                      
Ĵ
PC-Speaker   only a few sound effects are supported with PC-Speaker      
Ĵ
Soundblaster see SOUNDBLASTER manual                                     
Ĵ
D/A          see INFO.EXE  . digital/analog-converter on printerport     

This configuration will run on almost any hardware.
( This version was tested on:
  - an original IBM PS/2 Model 50.
  - COMPAQUE Deskpro 386/20e
  - AT 286 with 10 Mhz, no joystick, more than 580K memory, VGA with 256 K
  - 486 DX 33 Mhz; ET4000; Soundblaster; 2-joysticks
  - 386 DX 40 Mhz; Trident; D/A on LPT1; 1-Jostick
  - 386 DX 40 Mhz; ET3000; (you need to change video-adapter to type 2
  - AT 286 12 Mhz; ET4000
  - AT 286 16 Mhz; ET3000
  ....
  JOE also works with novell-netware.)

  DOS-Version:
  
  You must have a DOS-Version greater than DOS 3.00
  Tested on: DOS 3.3, DR-DOS and MS-DOS 5.0

  If you have trouble starting "YO! JOE!", remove all TSRs and
  all device drivers in CONFIG.SYS and AUTOEXEC.BAT first.


  Contact to SCIPIO :

     e-mail adresse : scipio@pool.informatik.rwth-aachen.de

